Fundamentals of GD&T, ASME Y14.5 - 2009, 4 PDH
(ASME Y14.5 - 2009 Fundamentals)

 This course requires an enrolment key

Online certificate training program for the Fundamentals of ASME Y14.5-2009, Geometric Dimensioning and Tolerancing (GD&T).

This training module will be available for 60 days after payment has been received.

Professional Development Hours (PDH) earned = 4.0 hours (Takes approximately 4 hours to complete).

This is an entry level training program and is best for those whom need an introduction to the concepts of dimensioning and tolerancing per. ASME Y14.5 - 2009, Geometric Dimensioning and Tolerancing.

The program is divided up into nine separate training modules with quizzes and one final test. Training modules are presented in a Power Point format with voice narration. Training pace is controlled by learner and all training modules may be repeated multiple times. The individual training modules will take between 10 and 25 minutes and include:

  • Down-loadable Geometric Characteristic Reference Chart

  • Differences between ASME and ISO geometric characteristics and symbols.
  • Glossary and Terms
  • Introduction and ASME Rules
  • Limit Tolerances
  • Datum's
  • Datum Targets
  • Feature Control Frame
  • Form Tolerances
  • Orientation Tolerances
  • Location Tolerances
  • Profile Tolerances
  • Runout Tolerances
  • Final Knowledge Test (required for certificate of completion)

One must receive an 80% correct or greater on all training modules quiz’s, as well as the final knowledge test to receive the Certificate of Training (instant download).

The following are the technology requirements for this training course.

  • Modern computer (PC with windows or MAC) not older than 8 years should do it.
  • Flash Player 10 Shockwave (Free), Windows or MAC: GET IT HERE.

Course Author Profile Kelly L Bramble

Cost: $79.00